On-board Grounding Contacts (SMT Type)
KITAGAWA INDUSTRIES America’s on-board grounding contacts are all tape-and-reel, SMT (Surface Mount) contacts for automated mounting onto PCB’s.
- Space-saving, grounding reinforcement at the design stage
- Effective for emission and ESD immunity reduction
- All EMC solutions can be done at the board-level, including grounding and shielding.
- Specially designed to prevent warping of springs
- Easy to incorporate even where screw holes are included
On-board contact : OG Series
KITAGAWA INDUSTRIES America carries a large selection of onboard contacts (OG) that are excellent grounding materials for reducing EMI noise at the board level. Also, these parts give the ability to ground in the areas where screws are not used.
On-board contact : OG-503253-A NEW!
SMT grounding contact for engine compartment PCB. Spring mechanism capable of withstanding 10 million deflections caused by engine vibration. Sustained conduction is secured because of unique dimple design.
On-board Clip: OGSC Series
KITAGAWA INDUSTRIES America also carries a unique onboard contact that makes contact with the vertical wall of a metal chassis and the PC board when making a grounding point between a top and bottom surface is not possible.
On-board Clip: OGP Series
These contacts work to ensure reliable contact at frame ground reinforcement or to solve contact failure problems caused by soldering flux.
On-board Clip: OGC Series
These onboard cable clamps are soldered onto the board to create a grounding point while holding a cable in place.
On-board Clip: OG-865028
Guiding mechanism for easy installation of shielding cans. Resin-coated core to protect cables. Can be applied at corners of shielding cans.
On-board Clip: OG-R Series
These onboard contacts are designed to support proper grounding around screw fixing hole area on the board.
On-board Clip: OGSR
Durable for grounding against vibrations and repeated compressions. Products with a wide range of use.
On-Board Shield Can Clips: OGCP series
These are unique onboard contacts that act as both shielding can holders and rounding components. KITAGAWA INDUSTRIES America’s OGCP makes re-work easy by having the clips soldered down to the board instead of the shielding can itself. It can be snapped into the clips and taken off when needed.
SMD Common Mode Filter: KWCM Series
Wire-wound structure allows for low insertion signal loss – small impact (less distortion) on signal waveform. Cancellation effect of magnetic flux is high when compared to filters with layered, thin film structure since higher coupling can be obtained between windings.
SMD Common Mode Filter: KWCM-HS Series
Wound wire common mode filters for automated mounting on PCB. Wire-wound structure allows for low insertion signal loss – small impact (less distortion) on signal waveform.
On-board Clip: OG-R Series
Application optimal for HDMI signals. Can be applied with reflow soldering. Matches characteristic impedance of 100Ω on which HDMI signal is carried. Small negative effect to high speed differential signal due to lower insertion loss.